Saginaw Control & Engineering SCE-4SPBH is a 4 position hinged push button enclosure. It is made from 0.063" carbon steel with an ANSI-61 gray powder coating and 30.5mm pushbutton entrances in a 2x2 layout. Useful for keeping oil-tight push buttons, switches, and pilot lights protected from dirt & moisture.

• 8.13" H x 8" W x 6" D (206.5mm x 203.2mm x 152.4mm)
• Seams are continuously welded
• Cover screws thread into sealed wells
• Bolt-on hinge with stainless steel hinge pin
• Works with any brand of oil-tight push buttons, switches, or pilot lights
• 4 way standard push button entrance
• Gasket is oil & water resistant
• Welded mounting plates located on the back at the top and bottom
• Powder coating on both the inside and outside
• Ground stud on door
• Sub-panel sold separately
• IS2 industry standards - NEMA Type 4, 12 and Type 13, UL Listed Type 4 and 12, CSA Type 4 and 12, IEC 60529, IP 66

Saginaw 4 Position Hinged Push Button Box SCE-4SPBH