Saginaw Control & Engineering SCE-16PBH is a 16 position hinged push button enclosure. It is made from 0.063" carbon steel with an ANSI-61 gray powder coating and 30.5mm pushbutton entrances in a 4x4 configuration. Made for keeping oil-tight push buttons, switches, and pilot lights protected from dirt & moisture.

• 12.13" H x 12" W x 6" D (308mm x 254mm x 152.4mm)
• Continuously welded seams
• Cover screws thread into sealed wells
• Continuous bolt-on hinge with stainless steel hinge pin
• Works with any brand of oil-tight push buttons, switches, or pilot lights
• 4 way standard push button entrance
• Oil / water resistant gasket
• Welded mounting plates located on the back at the top and bottom
• Powder coating on both the inside and outside
• Ground stud on door
• Sub-panel supported by standoffs (sold separately)
• IS2 industry standards - NEMA Type 4, 12 and Type 13, UL Listed Type 4 and 12, CSA Type 4 and 12, IEC 60529, IP 66

Saginaw 16 Position Hinged Push Button Box SCE-16PBH