 |
 |
 |
|
The Red Lion PAXLHV00 PAX LHV Lite series AC voltage panel meter has a 3 digit, red LED display in a 1/8 DIN housing. While monitoring AC voltages, it has a half-wave rectified input signal that shows the RMS value of the wave form. AC powered
Features
- 1/8 DIN Housing
- 3 Digit, Red LED Display
- Up to 600 VAC max
- Auto Zeroing Circuit
- NEMA 4X/IP65 - Front Panel
Red Lion PAX LHV Lite Series User Manual
Specifications
Display
3 digit, 0.56" (14.2 mm) red LEDs
Power Requirements
115 or 230 VAC, switch selectable. Allowable power line variation
+/-10%, 50/60 Hz, 6 VA. Installation Category II, Pollution Degree 2.
Isolation: 2300 Vrms for 1 min. to input
Working Voltage: 300 V max., CAT II
Accuracy: At 23 C, 85% R.H.; +/-(0.1% of Reading + 2 digits)
Input Impedance: 1 MOhm
Input Range: 0 to 600 VAC max. @ 45 to 500 Hz. Installation Category I
strong>Resolution: 1 VAC
Reading Rate: 400 msec., nominal
Response Time: 1 sec. nominal for a step change input
Standards Compliance
UL Recognized Component, File # E179259, UL61010A-1, CSA C22.2 No. 61010-1
UL Listed, File # E137808, UL508, CSA C22.2 No. 14-M95
Type 4X Enclosure rating (Face only), UL50
IECEE CB Scheme Test Report # 04ME11209-20041018
IEC 61010-1, EN 61010-1: Safety requirements for electrical equipment
for measurement, control, and laboratory use, Part 1.
IP65 Enclosure rating (Face only), IEC 529
Electromagnetic Compatibility: See user manual
Physical
Operating Temperature: 0 C to 60 C (32 F to 140 F)
Storage Temperature: -40 C to 80 C (-40 F to 176 F)
Humidity: 85% max. relative humidity (non-condensing)
Temperature Coefficient: +/-150 PPM/°C
Vibration to IEC 68-2-6: Operational 5 to 150 Hz, in X, Y, Z direction for 1.5 hours, 2 g's.
Shock to IEC 68-2-27: Operational 30 g, 11 msec in 3 directions
Altitude: Up to 2000 meters
Construction: NEMA 4X/IP65 outdoor use, Installation Category II, Pollution Degree 2,
One piece bezel/case; flame resistant; panel gasket & mounting clip
Connection: High Compression Cage-Clamp Terminal Block
Wire Strip Length: 0.3" (7.5 mm)
Wire Gage: 30-14 AWG copper wire
Torque: 4.5 inch-lbs (0.51 N-m) max.
Dimensions: 1.95" x 3.8" x 4.2"
|
|
|
 |
|
 |
|
