 |
 |
 |
|
The Red Lion PAXLC600 PAX LC Lite series 6 digit counter panel meter has a red LED display in a 1/8 DIN housing. This counter can be used for applications that require counting, measuring, or positioning readouts. Possible inputs can come from switch contacts, NPN-OC & TTL outputs, and Red Lion sensors. It accommodates uni-directional and bi-directional signals. Programming is done with DIP switches and the front panel buttons. A DIP switch can disable the front panel buttons after setup to avoid tampering or errors. AC powered
Features
- 1/8 DIN Housing
- 6 Digit, Red LED Display
- Input Count Rate Up to 25 KHz
- Bi-Directional Counting
- Remote Reset Capability
- Display Store
- Count Inhibit
- Programmable Scale Factor
- NEMA 4X/IP65 - Front Panel
Red Lion PAX LC Lite Series User Manual
Specifications
Display
6 digit, 0.56" (14.2 mm) red LEDs, (-99999 to 999999)
Power Requirements
AC Power: 115/230 VAC, switch selectable. Allowable power line variation
+/-10%, 50/60 Hz, 6 VA.
Isolation: 2300 Vrms for 1 min. to input and DC Out/In
Sensor Power
9 to 17.5 VDC @ 100 mA max.
Memory
Nonvolatile E2PROM retains programmable parameters & display values
Count Input
Logic State: Active Low
Input trigger levels VIL = 1.5 V max.; VIH = 3.75 V min.
Current Sinking: Internal 7.8 KOhm pull-up to +12 VDC, I max = 1.9 mA
Current Sourcing: Internal 3.9 KOhm pull-down, 8 mA max. @ 30 VDC max.
Filter: Damping capacitor provided for switch contact bounce. Limits input
frequency to 50 Hz and input pulse widths to 10 msec. minimum.
Control Inputs
Count Up/Down Control, Remote Reset, Inhibit, and Store
Max. Continuous Input: 30 VDC
Isolation To Sensor Input Commons: Not isolated
Logic State: Active Low, 22 KOhm pull-up to +12 V
Active: VIN < 0.9 VDC
Inactive: VIN > 3.6 VDC
Response Time:Up/Down and Inhibit: 25 usec max.
Reset and Store: 10 msec. max
Standards Compliance
UL Recognized Component, File # E179259, UL61010A-1, CSA C22.2 No. 61010-1
UL Listed, File # E137808, UL508, CSA C22.2 No. 14-M95
Type 4X Enclosure rating (Face only), UL50
IECEE CB Scheme Test Report # 04ME11209-20041018
IEC 61010-1, EN 61010-1: Safety requirements for electrical equipment
for measurement, control, and laboratory use, Part 1.
IP65 Enclosure rating (Face only), IEC 529
IP20 Enclosure rating (Rear of unit), IEC 529
Electromagnetic Compatibility: See user manual
Physical
Operating Temperature: 0 C to 60 C (32 F to 140 F)
Storage Temperature: -40 C to 70 C (-40 F to 158 F)
Humidity: 85% max. relative humidity (non-condensing)
Vibration to IEC 68-2-6: Operational 5 to 150 Hz, in X, Y, Z direction for 1.5 hours, 2 g's.
Shock to IEC 68-2-27: Operational 30 g, 11 msec in 3 directions
Altitude: Up to 2000 meters
Construction: NEMA 4X/IP65 outdoor use, IP20 Touch Safe, Installation Category II,
Pollution Degree 2, One piece bezel/case; flame resistant; Synthetic rubber keypad;
panel gasket & mounting clip
Connection: High Compression Cage-Clamp Terminal Block
Wire Strip Length: 0.3" (7.5 mm)
Wire Gage: 30-14 AWG copper wire
Torque: 4.5 inch-lbs (0.51 N-m) max.
Dimensions: 1.95" x 3.8" x 4.2"
|
|
|
 |
|
 |
|
