The BreezEV EVC-L2-48A-L1-1-NC-N-1 is a 48 Amp wall mount electric vehicle charger with RFID. It features Level 2 charging, which is compatible with every E-Vehicle manufacturer. Can be wall mounted or attached to a free-standing pedestal. One year or five year service plans are also available. Cables, mounting equipment, and service plans sold separately (see accessories below). See below for directions on how to order a complete charging station

• Ideal for residential use or in areas where a network software connection is not needed
• Unit does not have software capability
• RFID card reader
• 48 Amp max output, switchable down to 16 Amp
• Natural cooling
• UV resistant housing
• Can be used indoors or outdoors
• Comes with: charging unit, wall mount bracket, two M5 mounting screws, four M6 hexagonal mounting screws, accessory kit
• Accessory kit comes with fittings for incoming power wires, incoming power cable & charging cable, holster, and mounting screws for the holster

Specifications

• Housing Dimensions- 9.8" Width x 13.8" Length x 5.1" Depth
• Max Output- 48 Amps / 11.2 kW
• Rated Output Current- 16 / 32 / 40 / 48 Amps
• Input Voltage- 200-240V AC / Single Phase
• AC Power Frequency- 60 Hz
• Connector Type- SAE Type 1
• Input Protection- Undervoltage, Overvoltage, Reverse Charge, Surge Protection, Ground Fault Protection
• Output Protection- Overcurrent, Over Temperature, Control Pilot Fault Protection
• Storage Temperature- -40 F to 158 F
• Operating Temperature- -22 F to 122 F
• Ingress Protection- IP 65 (total protection from dust and low pressure water jets from any direction)
• Impact Resistance- IK08
• Warranty- 3 Year Manufacturer's Warranty

HOW TO ORDER

1. Required: Choose cable set (see accessories below). You can choose between 40A or 48A. Many current EV models cannot charge at higher rates, so the lower 40A cables would be sufficient. Then pick the cable length. All cables are field attached to the charger.
2. Optional: Choose mounting pedestals and brackets (see accessories below). Pedestals come with or without cable management. Bracket is only needed if two chargers will be installed side by side on the same pedestal. If you are wall mounting, you do not need any additional mounting accessories.
3. Optional: Choose 1 year or 5 year maintenance & service plan (see accessories below)

BreezEV Wall Mount Commercial EV Charging Station