The BreezEV EVC-L2-48A-L1-1-ET-D is a 48 Amp wall mount electric vehicle charger with RFID and Ethernet communication, and LCD screen. It features Level 2 charging, which is compatible with every E-Vehicle manufacturer. Can be wall mounted or attached to a free-standing pedestal. One year or five year service plans are also available. Cables, mounting equipment, and service plans sold separately (see accessories below). See below for directions on how to order a complete commercial electric vehicle charging station

Ideal for retail, commercial or municipal properties, or multi-unit housing
Unit does not come with AmpUp software pre-installed, in order for the user to install their own software (AmpUp software not available separately)
Allows for various payment options
Built-in LCD screen
Ethernet communication
RFID card reader
48 Amp max output, switchable down to 16 Amp
Natural cooling
UV resistant housing
LEDs indicate status
Can be used indoors or outdoors
Comes with: charging unit, wall mount bracket, two M5 mounting screws, four M6 hexagonal mounting screws, accessory kit
Accessory kit comes with fittings for incoming power wires, incoming power cable & charging cable, holster, and mounting screws for the holster

Specifications

Housing Dimensions- 9.8" Width x 13.8" Length x 5.1" Depth
Screen Size- 4.3"
Max Output- 48 Amps / 11.2 kW
Rated Output Current- 16 / 32 / 40 / 48 Amps
Input Voltage- 200-240V AC / Single Phase
AC Power Frequency- 60 Hz
Connector Type- SAE Type 1
Communication- Ethernet / RFID
Input Protection- Undervoltage, Overvoltage, Reverse Charge, Surge Protection, Ground Fault Protection
Output Protection- Overcurrent, Over Temperature, Control Pilot Fault Protection
Storage Temperature- -40 F to 158 F
Operating Temperature- -22 F to 122 F
Relative Humidity- 95% Relative Humidity
RJ45 Cable Inlet- 10M/100M Base-T
Ingress Protection- IP 65 (total protection from dust and low pressure water jets from any direction)
Impact Resistance- IK08
Warranty- 3 Year Manufacturer's Warranty

HOW TO ORDER

Required: Choose cable set (see accessories below). You can choose between 40A or 48A. Many current EV models cannot charge at higher rates, so the lower 40A cables would be sufficient. Then pick the cable length. All cables are field attached to the charger.
Optional: Choose mounting pedestals and brackets (see accessories below). Pedestals come with or without cable management. Bracket is only needed if two chargers will be installed side by side on the same pedestal. If you are wall mounting, you do not need any additional mounting accessories.
Optional: Choose 1 year or 5 year maintenance & service plan (see accessories below)

BreezEV EV Charger Installation Instructions

BreezEV Ethernet Connected Wall Mount EV Charger